ADCO provides turn-key installation services for:
- Complete boiler room install
- Burner, fuel and control installation and retrofits
- Stack economizer (heat recovery) installation
- Water treatment installation
- Skid packages
- Removal of old equipment
ADCO provides general repair services on your boiler as well as ASME code repairs. Repair services include:
- Tube rolling and replacement with certified welding
- Refractory repairs including front and rear doors, throat and liner, front and rear walls
- Pressure vessel repairs
- Jacket and insulation replacement
- Casing work
This Cleaver-Brooks boiler was one of two boilers purchased from a plant that closed down in 2017. This boiler was new in 2008 and produced steam for a facility making cast aluminum engines. As the plant began to close its operation, the maintenance of the boiler was neglected. Upon receipt of the boiler, ADCO’s service team provided a complete inspection of the pressure vessel, burner, controls
After completing the inspection, a list of defective items was identified and the process of rebuilding the unit to “like new” condition began. The boiler received:
- All new tubes
- New rear door
- New blowdown piping
- New low water cutoffs and piping
- Annual maintenance typical for a boiler of this age
- New paint
Upon completion, the boiler was shipped to its new owner.
Before 
After 
Before 
After 
Before 
After 
Before 
After
National Board "R" Stamp: ADCO holds a National Board of Boiler and Pressure Vessel Inspectors "R" Stamp.
ASME "S" Stamp: ADCO holds an ASME "S" Stamp, which allows us to make alterations to ASME Pressure Vessels and to perform field assembly.